Product Instruction


  • Keep out of reach of children
  • Wear protective gloves/mask
  • If on skin: wash with plenty of soap and water.
  • If in eyes : rinse cautiously with water for several minutes. Remove contact lens if present and easy to do continue rinsing.
  • if swallowed: immediately seek medical attention

Suitable for the safety standards of hazardous products based on the rate of registration and evaluation of chemicals.

Coatings instruction



Do NOT apply in direct sun or hot surface.

Work in ventilated and dust-free area.

Recommend skin & respiratory protection.

Do NOT mix with any other products.

Work under good light.

#1 – Shake the bottle, then apply several drops to saturate the Applicator.

*Tip – Always add drops as needed to keep the applicator damp and smooth for optimal application. This should be done for each small section you apply the ceramic coating to the vehicle.

#2 – Wipe a thin layer across the car surface. This should be completed first, in a horizontal pattern, then vertically to ensure an even application on each small section.

#3 – Continue to spread in a crisscross pattern until you have completely covered the section. Add drops as you go to keep the applicator cloth damp.

#4 –Once you’ve applied the coating to the full section, let it sit between 15-60 seconds. After the required wait time, you’ll proceed to the final phase of buffing. Buff off the residual. Once the coating has ‘flashed’, lightly buff the coated area with a microfiber towel until the cloudy surface has been removed. 

#5 – Finish other sections. After you’ve completed each section, continue around the car, working one section at a time. Complete all four steps as listed above on each section before moving to other areas.